Quote:
Originally Posted by CrazyJay
Tom I feel ya.... well, not literally... unless ya ask nice!
Don't ya hate it when you are routing and the edge gets thinner so your bushing guide slips off and ya cut right into the board.
I have about 5 boards that are 1/2" thinner than they were designed because of this.
Board looks sick!
|
Been there done that. Cursed like a sailor. Actually my router is such a P.O.S. (craftsman). There is a lot of play so when I push the guide against the template, the router bit will actually dig INTO the guide! After one board the guide is completely ruined.
Plus the kevlar/carbon in this board completely destroyed my 1/4" router bit.